Many bronze markers have spaces that are left empty for dates to be added at a later time. This is particularly common for “companion plaques” – bronze memorials that list two or more people. Sometimes the added information may not be a date. It could be a name or service branch or other information. But it’s the same process of adding what is commonly called a “plate,” “date plate” or “scroll plate.”
If you are looking to add a matching plate to an existing marker, here is our recommended approach:
First, try to determine the company that provided the scroll. Most likely they will have a design ready for replication and that will usually be the fastest and least expensive approach.
If that is not possible, you may have the option of replacing all the scrolls and avoiding a lot of potential matching problems. Although this is more expensive, it assures a better looking plaque. You can check by trying to unscrew one of the completed scrolls that are already on the plaque. But be careful – don’t scratch the bronze. Much of the time, the first scrolls on the plaque can not be removed because they are actually cast as part of the plaque. This is called “unicasting.” However, if all the plates can be replaced, this gives you the option of avoiding potential matching problems.
If you decide the only option is to match the existing scroll design, do the following:
- Measure the height and width of the bronze scrolls as accurately as possible.
- Determine if there have been screw holes already drilled into the blank area of the plaque in preparation for a new plate. Often there will be screws installed to protect the holes from filling with dirt and debris. Measure the distance between the screws or screw holes, center to center. This must be precise to assure that the new scroll can be successfully attached.
- If there are no screws or screw holes in the blank space, then take the measurements center to center of the screw holes in an existing scroll plate. In this case, there may be drilling required when it comes time to install the new scroll plate.
- Measure the height of the tallest letter or number on an existing scroll.
- Take as many pictures as possible of the entire plaque as well as close-ups of the scrolls. The color or shade of the bronze will be the hardest part to accurately match so the more pictures the better.
Here’s what NOT to do:
- Don’t take measurements in a decimal or metric format. Stick to inches with fractions, preferably in 1/16″ increments
- Don’t send us pictures with a ruler or tape measure on top of the plaque. (This will not help.)
This is a GOOD picture:
This is a BAD picture:
Once you’ve gathered all your information fill out and submit the form below:
- Please include measurements to the nearest 1/16″
- The more pictures the better of ALL the plates on the plaque so that we can better match the design.
What we will do:
There are numerous makers of bronze grave markers. Our initial step will be to identify the manufacturer. This task might pose challenges, especially if the monument dealer who sold the bronze memorial is defunct. Once we make a determination of the plate cost, we will email you with a quote.
IMPORTANT DISCLAIMER:
Matching existing date, name, or scroll plates on a bronze plaque is a tricky business. While Noble Bronze can match dimensions and hole locations based on the information you provide, we can NOT guarantee an exact match of color, texture, font or sculpted design. We can only offer our best efforts. If you are not comfortable with this level of assurance, please do NOT place an order.